139 lines
7.3 KiB
Plaintext
139 lines
7.3 KiB
Plaintext
SEAGATE TECHNOLOGY, INC.
|
|
Customer Technical Support FAX Network +1 408 438-8137
|
|
Customer Technical Support Bulletin Boards (300-9600, 8-N-1)
|
|
ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
|
|
³ United States +1 408 438-8771 ³ United Kingdom +44 628 478011 ³
|
|
ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ´
|
|
³ Germany +49 89 140-9331 ³ Singapore +65 227-2217 ³
|
|
ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
|
|
(C)opyright 1993
|
|
|
|
|
|
|
|
ST-352A/X AT/XT Interface
|
|
|
|
³J2 12-pin (located
|
|
³ on side, near rear)
|
|
ÀÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
|
|
³
|
|
1 3 5 7 9 11
|
|
(front) ß ø ø ø ø ø (back)
|
|
ø ø ø ø ø ø
|
|
ÍÍÍÍÍÏÍ2ÍÍ4ÍÍ6ÍÍ8ÍÍ10Í12ÍÏÍÍÍ
|
|
³ 4-pin DC
|
|
³
|
|
³ 3-pin DC AT/XT Interface Power
|
|
³ Power connector ÚÄ1Ä2Ä3Ä4Ä¿
|
|
³ ÕÍ1Í2Í3͸ ÕÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ͸ ³ 0 0 0 0 ³
|
|
ÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ 0 0 0 ³ ³:::::::::::::::::::1³ \12ÄGÄGÄ5Ä/
|
|
J2 Jumper Configurations³ ÍÏÍ5Í12GÍÏÍÏÍPÍWÍAÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏÍÍÍÍÍÍÍÍÍÍÍÍÍ
|
|
(12 pin version) ³
|
|
note: some jumpers are VERTICAL, others are HORIZONTAL
|
|
ÕÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍÍÍÍÍÍÍÍÑÍÍÍÍ͸
|
|
³ Jumper ³ Pin ³ AT Single ³ AT Master ³ AT Slave ³ XT ³
|
|
ÆÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍØÍÍÍÍÍÍÍÍÍØÍÍÍÍÍÍÍÍÍÍÍØÍÍÍÍÍÍÍÍÍÍÍÍØÍÍÍÍÍÍÍÍÍÍÍÍØÍÍÍÍ͵
|
|
³ Master/Slave ³ 1-2 ³ X ³ X ³ 0 ³ (3) ³
|
|
ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄ´
|
|
³ Slave Present ³ 3-4 ³ 0 ³ X ³ 0 ³ (3) ³
|
|
ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄ´
|
|
³ Active LED ³ 5-6 ³ X ³ X ³ 0 (2) ³ X ³
|
|
ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄ´
|
|
³ Slave ³ 5-7 ³ 0 ³ 0 ³ X (2) ³ 0 ³
|
|
³ ³ ³ ³ ³ ³ ³
|
|
ÌÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÎÍÍÍÍÍÍÍÍÍÎÍÍÍÍÍÍÍÍÍÍÍÏÍÍÍÍÍÍÍÍÍÍÍÍÏÍÍÍÍÍÍÍÍÍÍÍÍØÍÍÍÍ͹
|
|
º XT Mode º 7-8 º ³ X º
|
|
ÇÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÎÍÍÍÍÍÍÍÍ͹ ÃÄÄÄÄĶ
|
|
º XT Only: 40 º 1-2 º ³ X º
|
|
º Mbyte Cap. º ST351 º ³ º
|
|
ÇÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÎÍÍÍÍÍÍÍÍ͹ 12 pin version ÃÄÄÄÄĶ
|
|
º XT Only: 30 º 3-4 º ³ X º
|
|
º Mbyte Cap. º ST351 º ³ º
|
|
ÇÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÎÍÍÍÍÍÍÍÍ͹ ÃÄÄÄÄĶ
|
|
º XT Only: 20 º 1-2 & º ³ X º
|
|
º Mbyte Cap. º 3-4 º ³ º
|
|
ÌÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÎÍÍÍÍÍÍÍÍÍÎÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏÍÍÍÍ͹
|
|
³ Factory Test ³ 7-9 ³ FACTORY USE ONLY ³
|
|
ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄ´
|
|
³ Bus Reset (1) ³ 10-12 ³ 0 ³ 0 ³ 0 ³ 0/X ³
|
|
³ High ³ ³ ³ ³ ³ ³
|
|
ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄ´
|
|
³ Bus Reset (1) ³ 11-12 ³ X ³ X ³ X ³ X/0 ³
|
|
³ Low ÚÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÙ
|
|
ÀÄÄÄÄÄÄÄÙ X = Jumpered; 0 = No Jumper
|
|
|
|
(1) Bus reset active level. System dependent. A jumper must be
|
|
installed on either Bus Reset Hi or Bus Reset Low; the
|
|
drive will not function if neither set of pins is
|
|
jumpered.
|
|
|
|
(2) HSP/Assert "/DASP" signal: pin 39 on 40-pin AT/AT
|
|
Interface connector. The Host Slave Present jumper and the
|
|
Active LED jumper are mutually exclusive.
|
|
|
|
(3) XT only. These jumpers are used to set the drive type
|
|
information to be returned by the drive via the Drive
|
|
Configuration register (I/O port 2) or the XT Interface.
|
|
|
|
|
|
ST - 352A/X
|
|
|
|
UNFORMATTED CAPACITY (MB) ________________51
|
|
FORMATTED CAPACITY (17 SECTORS) (MB) _____42.82
|
|
AVERAGE SECTORS PER TRACK ________________
|
|
ACTUATOR TYPE ____________________________STEPPER
|
|
TRACKS ___________________________________
|
|
CYLINDERS _(Physical/Logical)_____________xx/980
|
|
HEADS ____________________________________2/5
|
|
DISCS ____________________________________1
|
|
MEDIA TYPE _______________________________THIN FILM
|
|
RECORDING METHOD _________________________RLL 2,7 (ZBR)
|
|
INTERNAL TRANSFER RATE (mbits/sec) _______10/12/14
|
|
SPINDLE SPEED (RPM) ______________________3,048
|
|
AVERAGE LATENCY (mSEC) ___________________9.84
|
|
INTERFACE ________________________________AT/XT
|
|
SECTORS PER DRIVE ________________________83,640
|
|
TPI (TRACKS PER INCH) ____________________1290
|
|
BPI (BITS PER INCH) ______________________27152/28155/28922
|
|
AVERAGE ACCESS (ms) ______________________28
|
|
SINGLE TRACK SEEK (ms) ___________________7
|
|
MAX FULL SEEK (ms) _______________________65
|
|
MTBF (power-on hours) ____________________150,000
|
|
POWER REQUIREMENTS: +12V START-UP (amps) _0.8
|
|
+12V TYPICAL (amps) __0.10
|
|
+5V TYPICAL (amps) ___0.11
|
|
TYPICAL (watts) ______2.0
|
|
MAXIMUM (watts) ______
|
|
BUFFERED STEP PULSE RATE (micro sec) _____
|
|
WRITE PRECOMP (cyl) ______________________N/A
|
|
REDUCED WRITE CURRENT (cyl) ______________N/A
|
|
LANDING ZONE (cyl)________________________AUTO PARK
|
|
IBM AT DRIVE TYPE ________________________40, 44*
|
|
|
|
Possible translation: 980 cyl, 5 heads, 17 sectors = 42,649,600
|
|
977 cyl, 5 heads, 17 sectors = 42,519,040
|
|
|
|
Note: A "custom" or "user-definded" CMOS drivetype may ask for a
|
|
numerical value for the Write Precompensation cylinder and for the
|
|
Landing Zone cylinder. A basic rule-of-thumb for drive models that do
|
|
not require the old Write Precomp technique or a Landing Zone because
|
|
they are Auto-Parking is to add 1 to the cylinder value being used. As
|
|
an example: If cylinders equaled 820, then both Write Precomp and
|
|
Landing Zone would be entered as 821. Some BIOS will convert this to
|
|
65535 or -1, which are functionally equivalent to "none (not used)".
|
|
|
|
* CHECK TO SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE"
|
|
DRIVE TYPE AVAILABLE. (see below)
|
|
|
|
PHYSICAL/LOGICAL equivalent to NATIVE/TRANSLATION
|
|
|
|
ZBR = Zone Bit Recording = Variable sectors per track
|
|
|
|
Already low-level formatted at the factory for AT installations.
|
|
|
|
Since a User-definable or Custom translation geometry may be used, it
|
|
is imperative that the values be written down and kept with your
|
|
permanent records for retrieval in the event of CMOS battery failure.
|
|
|
|
Seagate reserves the right to change, without notice, product
|
|
offerings or specifications. (10/7/93)
|
|
|