92 lines
4.5 KiB
Plaintext
92 lines
4.5 KiB
Plaintext
|
|
Recently, several new packeteers using PK-232s have appeared
|
|
on our local duplex repeater which is dedicated to packet
|
|
radio. This is one environment where the collision
|
|
frequency should be very low since there are no hidden
|
|
terminals. Almost immediately we noticed that the collision
|
|
frequency had risen dramatically. After some investigation
|
|
we discovered certain stations were almost guaranteed to be
|
|
involved in stepping on in-progress packets. These stations
|
|
were contacted and in all but 1 case they were new users of
|
|
PK-232s.
|
|
|
|
We were very puzzled as there have always been some stations
|
|
on the repeater using PK-232s with no apparent problems.
|
|
The new stations were asked how their station was configured
|
|
and what method was used to get the DCD operation adjusted.
|
|
We were very surprised at the answers we got. Every single
|
|
one of the offending stations had set their station up
|
|
exactly according to the instructions in the PK-232 manual.
|
|
However, contrary to the advice given in the manual, none of
|
|
these stations had configured their setup so that they could
|
|
hear what was going on on the channel when the PK-232 was
|
|
connected to the radio. None of these new operators knew
|
|
what DCD meant, what it did, or why it was important that it
|
|
should be working on a multiple access packet channel.
|
|
|
|
We obtained a PK-232 and manual to try and discover the
|
|
exact nature of the problem. What we found was that
|
|
although the manual is very complete and generally very
|
|
well written, there are some areas where it leaves something
|
|
to be desired. Specifically, in this case, the instructions
|
|
given on page 2-16 (we had manual PK232UG Rev. B 9/86 for
|
|
reference) for setting up the PK-232 and an FM radio for DCD
|
|
operation are simply incorrect. If set up exactly as
|
|
described, DCD will NEVER be asserted during a packet
|
|
transmission by another station on the channel!! We had
|
|
found the cause of our problem.
|
|
|
|
If you have a PK-232 and haven't already discovered this
|
|
problem for yourself, please disregard the instructions in
|
|
the manual for setting up a PK-232 and NBFM radio for 1200
|
|
baud packet operation and use the method presented here.
|
|
All your packet neighbors will appreciate it very much.
|
|
|
|
The manual is quite corect in all respects EXCEPT where they
|
|
discuss setting the DCD THRESHOLD control and receiver audio
|
|
output level for proper demodulation and DCD circuit
|
|
operation. The correct way to set these adjustments is as
|
|
follows:
|
|
|
|
1. At least temporarily, arrange to be able to hear
|
|
the receiver audio signal which is being sent to
|
|
the PK-232.
|
|
|
|
2. Set the squelch circuit on the radio for normal
|
|
squelched operation. The DCD circuit in the PK-232
|
|
is incapable of proper operation with unsquelched
|
|
audio from the receiver.
|
|
|
|
3. While monitoring incoming packets, adjust the
|
|
receiver audio level so that the tuning indicator
|
|
"spreads" fully when receiving a packet from the
|
|
station on the channel which produces the LEAST
|
|
amount of audio output level. There are several
|
|
limiters in the PK-232 demodulator so louder
|
|
stations will not be affected adversely by this.
|
|
|
|
4. Once the audio level is properly set, adjust the
|
|
DCD THRESHOLD control on the PK-232 so that the DCD
|
|
led lights when there is a packet being transmitted
|
|
by the station on channel which produces the LEAST
|
|
amount of audio output from the receiver. Make
|
|
sure, however, that the DCD LED is extinguished
|
|
when there is no signal and the radio's squelch
|
|
circuit has cut off all audio from the receiver.
|
|
|
|
If the above procedure is followed, the PK-232 will properly
|
|
hold off transmitting during a packet transmission from
|
|
another station and will not send acknowledgements to
|
|
individual frames of a maxframe greater than 1 packet while
|
|
it is still being transmitted.
|
|
|
|
We hope PK-232 owners will find this information useful and
|
|
take steps to assure that their DCD is operating properly.
|
|
Multiple access packet channel throughput is severely
|
|
degraded when DCD is not working.
|
|
|
|
73 and happy packeting,
|
|
|
|
Eric Gustafson N7CL
|
|
|
|
|